To connect the MYIRO-1 using WLAN to your computer you have to setup some details first.

  1. Connect MYIRO-1 using the USB cable to your computer and switch it ON.
  2. Start MYIROtools Measure
  3. Scan for connected instruments
  4. Select your MYIRO-1 
  5. Click Configuration

The network configuration dialogue allows you to enable or disable WLAN.
When it is enabled you can enter the details of your WLAN access point.
SSID: Name of your network
Security Key: Password
You can decide to use DHCP or a fixed TCP/IP setup.
Please ask your network administrator in case of doubts.

After you finished to enter all details click "Set".
Restart your MYIRO-1 by switching it OFF and then ON again.

To connect the MYIRO-9/FD-9 using LAN to your computer you have to setup some details first.

  1. Connect MYIRO-9/FD-9 using the USB cable to your computer and switch it ON.
  2. Start MYIROtools Measure
  3. Scan for connected instruments
  4. Select your MYIRO-9/FD-9 
  5. Click Configuration

The network configuration dialogue allows you to configure the settings to connect the MYIRO-9/FD-9 using Ethernet.

The network name can be chosen freely.

You can decide to use DHCP or a fixed TCP/IP setup.
Please ask your network administrator in case of doubts.

After you finished to enter all details click "Set".
Restart your MYIRO-9/FD-9 by switching it OFF and then ON again.