MYIROtools offers a very simple way to get things done called "Workflows".

A workflow is a wizard which guides you through all necessary steps to do a certain job like e.g. creating a profile for your printer. Every workflow contains instructions. Therefore this manual only describes the intention of the installed workflows briefly.

QC

QC is a folder. It contains workflows for quality control of prints. They are configured to use the standard quality control wedges and the most important reference printing conditions for different regions in the world.
You can check against the Contract Proofing Standard ISO 12647-7 or the Validation Print Standard ISO 12647-8. At the end of the wizard you get a QC report.

QC (EU/JP/US)

This workflow asks you to select

  • Control Wedge
  • Reference
  • Tolerance Standard

during the process. 
 

QC (EU)

This workflow uses the FOGRA MW 3.0 as control wedge to be measured.
You can choose FOGRA references and Proofing or Validation Print as tolerance.

QC (JP)

This workflow uses the Japan Color Control Strip 2013 or the Japan Color Control Strip 2018 as control wedge to be measured.
You can choose JapanColor references and Proofing or Validation Print as tolerance.

QC (US)

This workflow uses the IDEAlliance ISO 12647-7 wedge as control wedge to be measured.
You can choose IDEAlliance references and Proofing or Validation Print as tolerance.

This workflow is used to measure a chart and save the data as CGATS file.

During the workflow you can select the type of chart to be measured and the M-condition to be used for the final data.

This workflow is used to print and measure a chart and calculate a CMYK Output Profile.
During the workflow you can choose the type of chart, the print size and the profiling settings.

This workflow is used to print and measure a chart and calculate an RGB Output Profile.
During the workflow you can choose the type of chart, the print size and the profiling settings.